4|Pausing for ^0 60ths of a second.

4|Exiting dial modem procedure because an error occurred; error = ^0; category = ^1.

4|Received ENQ.

4|Received NAK.

4|Received ACK.

4|Block ^0 bytes long after packetizing.

4|EOF detected after ^0 total bytes read from file.

4|^0 bytes read from file.

4|Error occured reading file; error = ^0.

4|Error occured opening file; error = ^0.

4|DTR asserted.

4|DTR negated.

4|Exiting wait procedure because an abort request was detected.

4|Exiting wait procedure because an error occurred; error = ^0; category = ^1.

4|Timed out waiting for response.

4|Found "^2" in input stream at buffer position ^0.

4|Scanning ^1 bytes in input buffer starting at position ^0.

4|Waiting for ^2 in input stream within ^0 60ths of a second.

4|Read ^0 bytes from the $P.

4|Input buffer overflow by ^0 bytes.

4|Error occured on read from serial port; error = ^0.

4|Error occured on write to serial port; error = ^0.

4|Error occured on serial port SerStatus call; error = ^0.

4|Timout occured on write while waiting for serial port.

4|Writing ^0 bytes to the $P.

4|  ^2

4|The $P driver was successfully opened.

4|Error ^0 occured opening the $P input driver.

4|Error ^0 occured opening the $P output driver.

4|Closing the $P driver.

4|Opening the $P driver.

4|The $P driver is active.

4|The $P output driver is closed.

4|The $P input driver is closed.

4|The $P output driver is already open.

4|The $P input driver is already open.

4|Checking if the $P driver is already open.

4|Serial Port Arbitrator was detected.

4|Checking if Serial Port Arbitrator is available.

4|Input driver name is ^2 (^0), output driver name is ^3 (^1).

1|Aborting transmission.

2|Unable to locate a modem.

2|Unable to hang up the modem.

2|Hang up successful.

1|Hanging up the modem.

1|Transmission aborted.

2|Transmission failed.

2|Transmission successful.

1|Transmitting the information using EREG protocol.

2|Login successful.

2|Unable to get login verification.

3|Waiting for login verification.

1|Logging into the server.

1|Connected to the server.

2|Can not connect to server.

1|Connecting to the server.

3|The line is too noisy to transmit.

3|Checking for noise on the line.

3|Connected at $C baud.

2|The modem is unable to detect a dial tone.

2|The modem is unable to detect a carrier.

2|The line is busy.

2|Dial failed!

1|Dialing the modem.

3|Can't initialize the modem on the $P.

2|Modem found on the $P.

3|The $P is busy and was not forced open.

3|Switching to $B baud.

1|Looking for a modem on the $P at $B baud.